Main Site Documentation

SystemUpdate Issue?


#1

@ GHI,

So ChipworkX has been running great. Loads Pyxis and renders fast; minus that fact that I can run apps w/o the debugger attached it’s perfect.

But then I added SystemUpdates. These run perfectly on the Cobra and they’re OK on the ChipworkX too…until I plug in the Ethernet cable. At which point this thing just keeps rebooting over and over. It doesn’t even get as far as the section of code that tries to establish any sort of network connection.

Any thoughts?

UPDATE: Nevermind; seems I just shouldn’t connected the ethernet cable without a power cord attached.


#2

I was going to say that maybe the power source is not good enough. Glad you figured it out