Hello,
When I try to use FEZ Utility (by the way - helpful HAT ) in DMA mode, I always get exception in GIS.FEZUtility.CreateAsync():
Exception thrown: 'System.Runtime.InteropServices.COMException' in mscorlib.ni.dll
WinRT information: Failed to apply connection settings to the device.
System.Runtime.InteropServices.COMException (0x8007001F): A device attached to the system is not functioning.
Failed to apply connection settings to the device.
at System.Runtime.CompilerServices.TaskAwaiter.ThrowForNonSuccess(Task task)
at System.Runtime.CompilerServices.TaskAwaiter.HandleNonSuccessAndDebuggerNotification(Task task)
at GHIElectronics.UWP.Shields.FEZUtility.<CreateAsync>d__10.MoveNext()
--- End of stack trace from previous location where exception was thrown ---
at System.Runtime.CompilerServices.TaskAwaiter.ThrowForNonSuccess(Task task)
at System.Runtime.CompilerServices.TaskAwaiter.HandleNonSuccessAndDebuggerNotification(Task task)
at System.Runtime.CompilerServices.TaskAwaiter`1.GetResult()
at TK_FEZ_Utility2.MainPage.<Setup>d__2.MoveNext()
Any solution (other than go back to inbox driver)?