FEZ Raptor

Archive
1

Hello, I just got a FEZ Raptor and a USB Client SP 1.3. I have plugged the USB Client module into the D socket and the USB cable plugged from my computer into the client. I try to upload code from VS C# 2010 and I get an error.

Device not found or cannot be opened -
USB:Gadgeteer

I was thinking that maybe this is due to pulling too much power through the USB port but most pots can supply 500mA and the power estimate in the model viewer in VS C# says its below 500mA. I don’t know what else to do.

2

Check this thread and my post in it for a possible solution.

https://www.ghielectronics.com/community/forum/topic?id=14413

3

Thanks duke!! I re-flashed the firmware and restarted my computer and it works just fine.