FEZ Config setting LCD is painful

Archive
1

I am trying to configure some G400-D modules for LCD and everytime I try to input the value, a few second later all the values reset to ZERO.

This is repeatable and now I can’t do any LCD config even if I am fast enough with the input it reports that a width of ZERO is not valid.

Version is 4.3.7.10

Tiny booter is up to date and so is the firmware. It’s just this damn LCD config page that messes up. :frowning:

2

@ Dave McLaughlin - If you put the G400 in TinyBooter mode by holding down LDR1 at startup, can you se the values?