Hello, Is anybody else using this combination? I am using the full keil MDK/ARM toolchain to build netmf 4.4 and using uVision to debug the netmf.
It was working fine until recently and I was wondering if anyone else is working using a similar setup.
Specifically I am working on the Discovery stm32f407 board.
thanks
@ Dale Lyons - Dale, on another topic, what country are you in? We have folks from all over.
@ Dale Lyons - Do you wittness a break in the netmf build ?
I’ve got some too, using the latest bits from the github repo but by using the arm-gcc fraction. Used two different version but got the same error with either, at least it’s consequent …
Haven’t looked very much into it though.