I get an “There was an error during the upload” status after updating my FEZ Duino from latest preview to RC1.
Device was not listed in the Port Dropdown only COM3 (GHI Electronics) after power off and on the device everything works as expected with the new firmware
I used the RC1 TinyCLR Config Tool and the ITCore-SC20-Firmware-v2.1.0.5000.ghi Firmware.
I can see this after upload too, (probably just trouble to enumarate fast enough after reboot), you can list the device in a drop down menu without trouble, So it is just a message after firmware upload, I can see this every time, no version dependence. But it looks like its OK. so I never tried to think about that.
if i uninstall and plugin my FEZ Duino it shows up again.
Yes, it should be like that.
The firmware and the device is working so it’s not really a problem.
Yes, problem here is PC doesn’t refresh USB port, and unfortunately I couldn’t reproduce on my PC. Nothing wrong with firmware or device. You can go ahead continue your project.
I tried the update on a different computer
Works fine here
I wish I can have the PC to see what wrong with our analyzer tool. :))