Main Site Documentation

Not able to download VS 2017 generated files to G30 Module


#1

Hi
I believe I have the TinyCLR firmware loaded to a G30 module but I am not able to download the VS 2017 generated files to the module.

The VS output would seem to show it “sees” the G30…
Message output is …
Looking for a device on transport ‘USB’.
Found device port ‘USB’ with ID ‘2d3de7bd-9718-4e91-9de2-04ea62fb3de1’ for transport ‘Usb’.
Starting device deployment.
Attempting to connect to device ‘USB:G30’: iteration 0.
Opening port ‘\?\usb#vid_1b9f&pid_0110#7&202a63e0&0&1#{c13bcfe9-5e84-4187-9baa-45597ffcbb6f}’.
Attaching debugger engine.
Debugger engine attached.
Querying device assemblies.
Found assemblies:
Generating device specific assemblies.
Deploying assemblies:…(file names)

But momentarily I get an error message…
An error has occurred: please check your hardware…

I tried a new bare project (C#) and it does the same thing.

Any suggestions on things I should try or check would be welcome.

Thanks…Gus50310


#2

What extension version did you install?

What firmware did you load on your G30?

Did you start a new project and try to load without adding any additional code?


#3

Thanks for the quick reply Gus
Actually I was about ready to delete my post. I thought I had installed 0.5.0 extension before but redid it for kicks and now a empty new project does load. I had loaded 0.5.0 firmware.
Gus50310


#4

Good luck and keep us posted