G400-S and built in Ethernet?

[dottedquad]

Hi, in the process of troubleshooting my G400-s raptor I accidently setup and sent the ip configuration and mac address while I was in the Builtin Ethernet section of the Fez Config software. I then went to the Ethernet ENC28 tab and sent that configuration to the Raptor.

I know the G400-s only supports Ethernet ENC28 so, will there be any conflicts or did I write over the builtin ethernet settings when I resent the Ethernet ENC28 config?

[Dat_Tran]

@dottedquad

Hi, in the process of troubleshooting my G400-s raptor I accidently setup and sent the ip configuration and mac address while I was in the Builtin Ethernet section of the Fez Config software. I then went to the Ethernet ENC28 tab and sent that configuration to the Raptor.

I know the G400-s only supports Ethernet ENC28 so, will there be any conflicts or did I write over the builtin ethernet settings when I resent the Ethernet ENC28 config?

There should not be conflicted, what you did in ethernetbuildin will only effect to ethernetbuildin. You have to setup in ENC28 separately.

[dottedquad]

@Dat

There should not be conflicted, what you did in ethernetbuildin will only effect to ethernetbuildin. You have to setup in ENC28 separately.

Alright. Thanks